844
edits
Changes
Jump to navigation
Jump to search
mLine 18:
Line 18: − +
How to 3D Print a Squirrel on the Makerbot Replicator (view source)
Revision as of 15:19, 9 September 2013
, 15:19, 9 September 2013→Slicing
** Select ''Use'' '''Right''' ''extruder.''
** Select ''Use'' '''Right''' ''extruder.''
* Press the "Generate Gcode" button.
* Press the "Generate Gcode" button.
* If you get the warning that you are using accelation settings, it is safe to ignore. The firmware on the Makerbot Replicator is able to handle acceleration.
* If you get the warning that you are using acceleration settings, it is safe to ignore. The firmware on the Makerbot Replicator is able to handle acceleration.
Slicing can take some time, the more complicated the model, the more time it will take.
Slicing can take some time, the more complicated the model, the more time it will take.