22
edits
Changes
Jump to navigation
Jump to search
Line 50:
Line 50: + + + +
no edit summary
The outer dies can be placed in three positions on either side of the tube roller as shown below. The position on the outside (position 1) requires the least amount of force to bend material while the innermost position (position 3) requires the most force to bend material. The placement of the dies also affects the bend radius.
The outer dies can be placed in three positions on either side of the tube roller as shown below. The position on the outside (position 1) requires the least amount of force to bend material while the innermost position (position 3) requires the most force to bend material. The placement of the dies also affects the bend radius.
When you change the die position, be careful to make sure both dies are fully seated. The axles fit snugly into the notches and they may need to be pushed into position.
When you change the die position, be careful to make sure both dies are fully seated. The axles fit snugly into the notches and they may need to be pushed into position.
[[File:HulkPosition1.jpg|400px]]
[[File:HulkPosition2.jpg|400px]]
[[File:HulkPosition3.jpg|400px]]
== Handle Leverage Adjustment ==
== Handle Leverage Adjustment ==