Domain Admins
296
edits
Changes
Jump to navigation
Jump to search
Line 60:
Line 60: − {| class="wikitable" border="1"+ − ! Description − ! Frequency − ! Lubricant − ! Instructions − ! History − |- − |Hydraulic cylinder − |Maintain level at top of oil cup. − | − | − | − |- − |Gear Box − |yearly − |80W-90 gear oil − |Drain and fill with 3 ounces of oil. − Requires removing gearbox. See below. − |2/14 8 oz 85W90 − |- − |Pivot bar − |monthly − |General purpose grease − |2 Zerk fittings. Use grease gun. One of the fittings is clogged and not taking grease. We should try a higher pressure gun or replace the fitting. − | − |} − Gearbox oil change. Loosen 2 screws on the left edge of right top cover. Remove top 2 screws on the right side. Loosen bottom 2 screws on the right side cover. Slide top cover towards the center of the saw. Pivot the right cover down. Remove drive belt. Remove gearbox step pulley. Remove 3 bolts holding the gearbox. These are near the ring gear teeth. Remove the gearbox out the top of the saw between the two transverse brackets (long shaft comes out last). Drain/fill bolt is on the side opposite the pinion gear. Consider replacing the gaskets on the gearbox.
→Maintenance
== Maintenance ==
== Maintenance ==
[[Johnson_Bandsaw_maintenance | maintenance page]]
== Auth/Use Notes ==
== Auth/Use Notes ==