Changes

== Status ==

== Status ==

* A VFD has been fitted, this allows the machine to run on a 110v circuit and provides a variable speed control. The RPM display shows the RPM of the drive wheel (16"), the blade speed will be approx. 4.18 * RPM. The power switch on the left side of the control box applies power to the VFD. The on/off button on the front panel and the limit switch control the blade, the button must be out for on and the limit switch up to run. The button switch serves as an emergency switch, pull for on push for off. The dial controls RPM.  

* A VFD has been fitted, this allows the machine to run on a 110v circuit and provides a variable speed control. The display shows the RPM of the drive wheel (16") * 4 which is approximately blade speed in FPM. The power switch on the left side of the control box applies power to the VFD. The on/off button on the front panel and the limit switch control the blade, the button must be out for on and the limit switch up to run. The button switch serves as an emergency switch, pull for on push for off. The dial controls RPM.  

- Jim Brink 12/10/16  

      - Jim Brink 12/10/16  

* The large groove (fastest speed) of the motor shaft step pulley is bent.  The motor vibrates excessively when the belt is in this groove.  Use the other grooves (slower speeds) until the pulley is replaced.

* The large groove (fastest speed) of the motor shaft step pulley is bent.  The motor vibrates excessively when the belt is in this groove.  Use the other grooves (slower speeds) until the pulley is replaced.