* Raster settings (for engraving) are applied to strokes within the image that’s over a hairline (as defined above), while vector settings (for cutting) are applied to hairlines. If you have a combo image, you’ll have to set both. These settings depend on the material properties and thickness and there is a handy reference [[Laser settings]] chart on the wall with commonly used materials. | * Raster settings (for engraving) are applied to strokes within the image that’s over a hairline (as defined above), while vector settings (for cutting) are applied to hairlines. If you have a combo image, you’ll have to set both. These settings depend on the material properties and thickness and there is a handy reference [[Laser settings]] chart on the wall with commonly used materials. |