1,524
edits
Changes
From Pumping Station One
Laser Cutter Instructions and Workflow (view source)
Revision as of 22:25, 19 May 2017
, 22:25, 19 May 2017→Configuring Laser Settings
* Set “Engrave Direction” to “Bottom Up” as cutting in that manner works better with the airflow through the machine.
* Set “Engrave Direction” to “Bottom Up” as cutting in that manner works better with the airflow through the machine.
* Dithering settings can usually be left alone, except in the cases of specialized images.
* Dithering settings can usually be left alone, except in the cases of specialized images.
* “Vector Sorting”, which determines which cuts are made first should be checked. Generally optimize is fine.
* “Vector Sorting”, which determines which cuts are made first should be checked. Generally optimize is fine. Concentric however, prevents small inner cuts from becoming out of register to the outer cuts, which can result from bits falling away from the material and shifting a bit to the side before the cuts are done.
* Frequency Automatic can generally be left alone.
* Frequency Automatic can generally be left alone.
* Click OK.
* Click OK.
