Difference between revisions of "Laser Cutter maintenance"
| Line 5: | Line 5: | ||
| − | + | Checklist for issues | |
| + | ------------------------------ | ||
| − | + | ||
| + | Checklist for normal use | ||
| + | -------------------------------------- | ||
[ ] Clean-up the grid table | [ ] Clean-up the grid table | ||
| Line 22: | Line 25: | ||
| − | + | Checklist for maintenance | |
| + | ----------------------------------------- | ||
| + | |||
Some of these actions require some experience and care, ask someone who have done that before attempting anything. | Some of these actions require some experience and care, ask someone who have done that before attempting anything. | ||
Latest revision as of 18:12, 22 October 2015
This is an attempt at making a document for the maintenance of the laser cutter.
The main purpose is to make a single-sheet checklist for issues and one single-sheet for maintenance work.
Checklist for issues
Checklist for normal use
[ ] Clean-up the grid table
[ ] Clean around the computer and the machine (remove waste)
[ ] Empty and vacuum the tray
[ ] Vacuum the interior of the machine
[ ] Turn everything off (air-assist, venting system, machine, computer)
[ ] Take your USB key
Checklist for maintenance
Some of these actions require some experience and care, ask someone who have done that before attempting anything.
[ ] Cleaning of fans
[ ] Cleaning of optics
[ ] Cleaning of laser tube
[ ] Cleaning of optics
[ ] Level table
[ ] Alignment of optics
[ ] Alignment of rulers
[ ] Set focus/autofocus
[ ] Set absolute origin