533
edits
Changes
From Pumping Station One
→To-Do
Have found a rail and trolley setup that will hang from the rafters and support a 500# lifting capacity winch.
Have found a rail and trolley setup that will hang from the rafters and support a 500# lifting capacity winch.
|-
|-
|
|done
|Taper attachment needs to be cleaned and tested
|Taper attachment needs to be cleaned and tested
|Abel Greenwald
|Abel Greenwald
-Test cuts have been made, and we are able to cut an actual round, non tapered, cut to measure first, and created a dead(ish) center for the headstock. We used our new center along with the live center we have to measure the general alignment between the headstock and the tailstock. The gauge bar had a .003" slope over 24". However we were able to get .003" flex on the live center, and that bar weighs 20+lbs so not too bad. On the side to side alignment, there was a .001" taper over 24" with the tailstock being slightly closer to the operator than the headstock. Abel and I did not try to chase that .001" out on Saturday, but if we feel that is too much error we can take a crack at it.
-Test cuts have been made, and we are able to cut an actual round, non tapered, cut to measure first, and created a dead(ish) center for the headstock. We used our new center along with the live center we have to measure the general alignment between the headstock and the tailstock. The gauge bar had a .003" slope over 24". However we were able to get .003" flex on the live center, and that bar weighs 20+lbs so not too bad. On the side to side alignment, there was a .001" taper over 24" with the tailstock being slightly closer to the operator than the headstock. Abel and I did not try to chase that .001" out on Saturday, but if we feel that is too much error we can take a crack at it.
|-
|-
|
|done
|Any tooling needed?
|Any tooling needed?
|
|
|Spoke to Roger (888-532-5663) LeBlond does not have a product or document to retrofit this machine 5/30
|Spoke to Roger (888-532-5663) LeBlond does not have a product or document to retrofit this machine 5/30
|-
|-
|
|done
|Need to mount a guard
|Need to mount a guard
|
|
