Difference between revisions of "Peristaltic pump controller"
Jump to navigation
Jump to search
(Created page with 'Category:Brewing {{Template:EquipmentPage |owner = Ryan Pierce |certification = yes |hackable = NO |model = ? |serial = Unknown |arrived = November, 2012 |doesitwork = WORKI…') |
m |
||
| (6 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| − | |||
| − | |||
{{Template:EquipmentPage | {{Template:EquipmentPage | ||
|owner = Ryan Pierce | |owner = Ryan Pierce | ||
| Line 8: | Line 6: | ||
|serial = Unknown | |serial = Unknown | ||
|arrived = November, 2012 | |arrived = November, 2012 | ||
| − | |doesitwork = | + | |doesitwork = yes |
|contact = Ryan Pierce | |contact = Ryan Pierce | ||
|where = [[Beer Church]] | |where = [[Beer Church]] | ||
|value = $140 | |value = $140 | ||
}} | }} | ||
| + | |||
| + | == Operation == | ||
| + | |||
| + | TODO: write up properly. For now, just hints: | ||
| + | |||
| + | Make sure to screw on the retainer clamp... but not too tight. It's only there to prevent the tubing from walking in the housing, which can cause it to get eaten up. Do'nt clamp it so hard it leaves marks. When you're done using the pump remove the tubing shortly thereafter, leaving it clamped can dent the tubing permanently. | ||
| + | |||
| + | == Accessories == | ||
| + | |||
| + | * [http://www.amazon.com/gp/product/B000FOWH7U/ref=oh_details_o00_s00_i00 Translucent Tygon Tygoprene Tubing, 1/4" ID, 3/8" OD, 1/16" Wall, 10' Length] is the tubing used with this device. | ||
== List of Currently Certified Users == | == List of Currently Certified Users == | ||
| Line 28: | Line 36: | ||
|Ryan Pierce | |Ryan Pierce | ||
|} | |} | ||
| + | |||
| + | [[Category:Brewing]] | ||
| + | [[Category:Photographs Needed]] | ||
| + | [[Category:Loaned Equipment]] | ||
Latest revision as of 16:52, 16 August 2017
| Owner/Loaner | Ryan Pierce |
|---|---|
| Serial Number | Unknown |
| Make/Model | ? |
| Arrival Date | November, 2012 |
| Usability | yes |
| Contact | Ryan Pierce |
| Where | Beer Church |
| Authorization Needed | yes |
| Hackable | NO |
| Estimated Value | $140 |
| Host Area | {{{hostarea}}} |
Operation
TODO: write up properly. For now, just hints:
Make sure to screw on the retainer clamp... but not too tight. It's only there to prevent the tubing from walking in the housing, which can cause it to get eaten up. Do'nt clamp it so hard it leaves marks. When you're done using the pump remove the tubing shortly thereafter, leaving it clamped can dent the tubing permanently.
Accessories
- Translucent Tygon Tygoprene Tubing, 1/4" ID, 3/8" OD, 1/16" Wall, 10' Length is the tubing used with this device.
List of Currently Certified Users
| Qualified Member | Trained By |
|---|---|
| Ryan Pierce | Owner |
| Eric Stein | Ryan Pierce |
| Brittany Zimmerman | Ryan Pierce |