1,555
edits
Changes
From Pumping Station One
Peristaltic pump controller (view source)
Revision as of 05:28, 10 February 2013
, 05:28, 10 February 2013note about clamp tightness
|value = $140
|value = $140
}}
}}
== Operation ==
TODO: write up properly. For now, just hints:
Make sure to screw on the retainer clamp... but not too tight. It's only there to prevent the tubing from walking in the housing, which can cause it to get eaten up. Do'nt clamp it so hard it leaves marks. When you're done using the pump remove the tubing shortly thereafter, leaving it clamped can dent the tubing permanently.
== Accessories ==
== Accessories ==
