9
edits
Changes
Jump to navigation
Jump to search
Line 42:
Line 42: − + − + + − put info here+ + − + − Remove existing spool, if necessary. + − put more info here. − + − put info here − + − put info here - note: for the 203 OctoPrint printer, you can control & monitor bed & nozzle temps+ − + − + − Put info about Prusa Slicer here...+ + + + + + + +
no edit summary
== Operation ==
== Operation ==
===1. Prepare the Printer===
===Prepare the Printer===
====''1a. Clean the nozzle''====
====Check/Load material spool''====
Remove any other printed models from the bed if they are finished and set aside. If the owner left contact information, leave it with the model.
====Clean the bed''====
=====Before printing with PLA or ABS, but not PETG, clean with a few light swipes of an alcohol wipe =====
====''1b. Check/Load material spool''====
====Set printer settings for your job''====
=====You can control & monitor bed & nozzle temps and other parameters from OctoPrint =====
====''1c. Clean the bed''====
===Prepare Your .STL file===
====''1d. Set printer settings for your job''====
====Open your .STL model file in PrusaSlicer, Cura, or other slicer software''====
====Orient the model onto the bed''====
====Set values for various parameters:====
===2. Prepare Your .STL file===
=====Nozzle and bed temperature=====
=====Print quality/layer thickness=====
=====Infill percent=====
=====Other settings as needed=====
====Slice the model.''====
====Note the estimated time to print.''====
====Save the resulting .GCODE file.''====
===Open OctoPrint in a browser tab===
===Upload .GCODE to OctoPrint.===