Difference between revisions of "Recurring Maintenance"
Jump to navigation
Jump to search
Tachoknight (talk | contribs) |
|||
Line 22: | Line 22: | ||
==Hot Metals Area== | ==Hot Metals Area== | ||
+ | * Clean table with chop saw, sander, etc. | ||
+ | * Sweep floor, especially by floor-standing grinder and welders | ||
+ | * Clean outside of cabinets | ||
+ | * Replace water in barrel | ||
+ | * Ensure there are shop (blue) paper towels by the sink | ||
+ | * Wash cotton welding jackets | ||
==Cold Metals Area== | ==Cold Metals Area== |
Revision as of 18:19, 18 August 2015
General Area
- Put equipment labels on equipment that is missing an equipment label (make a new wiki page if necessary).
- Move items in the Wut Zone to Limbo
- Throw out / Recycle Limbo items.
- Dust the top of the dust collections pipes
- Empty the dust collector bins and clean the filter stack by connecting a vacuum to the cleanout port.
- Audit member shelves.
- Change filter in upstairs HVAC (every 30 days): HVAC#Filter.
- Oil the pumps in the boiler room (annually): HVAC#Pumps.
CNC Area
- Grease Shopbot rails
- Clean underneath and around Shopbot
- Remove ticketed materials from
- under the Shopbot
- under the Shapeoko
- Organize vinyl
Electronics Area
Crafts Area
Hot Metals Area
- Clean table with chop saw, sander, etc.
- Sweep floor, especially by floor-standing grinder and welders
- Clean outside of cabinets
- Replace water in barrel
- Ensure there are shop (blue) paper towels by the sink
- Wash cotton welding jackets
Cold Metals Area
- Lubricate the manual Bridgeport milling machine head.
- Grease Doall bandsaw (1 zerk under big metal cover).
- Grease Johnson bandsaw (2 zerks on pivot shaft).