Difference between revisions of "Recurring Maintenance"
Jump to navigation
Jump to search
Line 3: | Line 3: | ||
*Move items in the Wut Zone to Limbo | *Move items in the Wut Zone to Limbo | ||
*Throw out / Recycle Limbo items. | *Throw out / Recycle Limbo items. | ||
− | * | + | *Vacuum the top of the dust collections pipes |
*Empty the dust collector bins and clean the filter stack by connecting a vacuum to the cleanout port. | *Empty the dust collector bins and clean the filter stack by connecting a vacuum to the cleanout port. | ||
*Audit member shelves. | *Audit member shelves. |
Revision as of 15:30, 20 August 2015
General Area
- Put equipment labels on equipment that is missing an equipment label (make a new wiki page if necessary).
- Move items in the Wut Zone to Limbo
- Throw out / Recycle Limbo items.
- Vacuum the top of the dust collections pipes
- Empty the dust collector bins and clean the filter stack by connecting a vacuum to the cleanout port.
- Audit member shelves.
- Change filter in upstairs HVAC (every 30 days): HVAC#Filter.
- Oil the pumps in the boiler room (annually): HVAC#Pumps.
CNC Area
- Grease Shopbot rails
- Clean underneath and around Shopbot
- Remove ticketed materials from
- under the Shopbot
- under the Shapeoko
- Organize vinyl
Electronics Area
Crafts Area
Hot Metals Area
- Clean table with chop saw, sander, etc.
- Sweep floor, especially by floor-standing grinder and welders
- Clean outside of cabinets
- Replace water in barrel
- Ensure there are shop (blue) paper towels by the sink
- Wash cotton welding jackets
Cold Metals Area
- Lubricate the manual Bridgeport milling machine head.
- Doall bandsaw- oil Reeves drive shaft (SAE 10 in oil cup under the big metal cover).
- Grease Johnson bandsaw (2 zerks on pivot shaft).