Line 95: |
Line 95: |
| <gallery> | | <gallery> |
| File:Rockwell_Label.JPG|Label | | File:Rockwell_Label.JPG|Label |
| + | File:Rockwell_Indentor_Holder.jpg|Holder for indentor |
| File:Rockwell_Anvil_adjust.JPG|Handwheel to adjust the anvil to apply the minor load | | File:Rockwell_Anvil_adjust.JPG|Handwheel to adjust the anvil to apply the minor load |
| File:Rockwell_Major_Load_Lever.JPG|Major Load Lever | | File:Rockwell_Major_Load_Lever.JPG|Major Load Lever |
Line 103: |
Line 104: |
| Select the correct indentor - diamond for HRC other material for HRC ( what is an indentor? need identification and use of indentors in stock) | | Select the correct indentor - diamond for HRC other material for HRC ( what is an indentor? need identification and use of indentors in stock) |
| | | |
− | 1) Install indentor (photo ?) | + | 1) Install indentor |
− | 2) Support load (how?) | + | 2) Place component on anvil, use a specialized anvil if needed ( eg. round stock) |
− | 3) Place component on anvil, use a specialized anvil if needed ( eg. round stock)
| + | 3) Turn handwheel to apply the 'minor load' until needle points to indicator mark on dial. |
− | 4) Turn handwheel to apply the 'minor load' until needle points to indicator mark on dial. ( id handwheel photo?) | + | 4) Zero out dial. |
− | 5) Zero out dial. | + | 5) Depress lever to apply 'major load' , allow time to settle. |
− | 6) Depress lever to apply 'major load' , allow time to settle. (where is lever? what is depress? move forward?) | + | 6) Release lever |
− | 7) Release lever | + | 7) Read dial for hardness. (photo example how?) |
− | 8) Read dial for hardness. (photo example how?) | |
| | | |
| == Testing == | | == Testing == |