385
edits
Changes
From Pumping Station One
Screen Printing Workshop first test (view source)
Revision as of 05:29, 19 February 2009
, 05:29, 19 February 2009Updates
* I burned the screen for 15 minutes, checked it, uneducated guess is that it needs more time to expose. Check again in 15 more minutes. (10:34 PM)
* I burned the screen for 15 minutes, checked it, uneducated guess is that it needs more time to expose. Check again in 15 more minutes. (10:34 PM)
** Now is a good time to note that I should have attached my positive to the screen so when I checked it the alignment wouldn't get messed up.
** Now is a good time to note that I should have attached my positive to the screen so when I checked it the alignment wouldn't get messed up.
* I decided to let it stay for another 30 that way if it overexposed I would have a high point of reference. From what little experience I have it doesn't seem to have changed much. The emulsion basically just gets ''slightly'' more transparent.
* After 45 minutes I pulled the screen off the light and washed out the print areas with my high pressure spray nozzle. It takes a minute or two for the areas to start clearing out (I was worried) but then slowly they will empty out.
* Letting screen dry completely will I prepare my kitchen table for test prints.
== Result ==
== Result ==
