Line 40: |
Line 40: |
| 1. Waste board repaired or replaced. Entire board is unsupported in the middle, causing it to sag. Also, one stud has pulled up a volcano-like mountain in one part of the waste board, and needs to be milled down. Recommend getting two $7 20mmx20mmx300mm extrusions (from Inventables or elsewhere) and T-nuts to support it in the middle (this is a common upgrade for this particular machine). | | 1. Waste board repaired or replaced. Entire board is unsupported in the middle, causing it to sag. Also, one stud has pulled up a volcano-like mountain in one part of the waste board, and needs to be milled down. Recommend getting two $7 20mmx20mmx300mm extrusions (from Inventables or elsewhere) and T-nuts to support it in the middle (this is a common upgrade for this particular machine). |
| | | |
− | 2. Bearing blocks on all axis need to be tuned. Some are not making contact, and gantry is not square to waste board. | + | 2. Bearing blocks on all axis need to be tuned. Some are not making contact, gantry is not square to waste board, and spindle is not square either. |
| | | |
| 3. Spindle PWM, both power supplies, and perhaps the GRBLShield should be mounted in a compact, fan-cooled enclosure. I'd love said enclosure to be part of a full machine enclosure that incorporates noise suppression, interior lighting, and dust collection. | | 3. Spindle PWM, both power supplies, and perhaps the GRBLShield should be mounted in a compact, fan-cooled enclosure. I'd love said enclosure to be part of a full machine enclosure that incorporates noise suppression, interior lighting, and dust collection. |
| | | |
− | 4. Install Homing and limit switches, and connect to GRBLShield. This should prevent some crashes. | + | 4. Finish Programming Homing and limit switches. This should prevent some crashes. |
| | | |
| 5. General wiring clean-up and sheathing: some connectors have bare leads exposed, and I'd love to clean up the build by sheathing many of the wires. | | 5. General wiring clean-up and sheathing: some connectors have bare leads exposed, and I'd love to clean up the build by sheathing many of the wires. |
| | | |
− | 6. Label axis, electrical components, etc with a label-maker for ease of understanding.
| |
| | | |
| == Documentation == | | == Documentation == |
Line 111: |
Line 110: |
| | [[User:esp | Jeremy fay]] | | | [[User:esp | Jeremy fay]] |
| | [[User:ad9581 | Arturo Duarte]] | | | [[User:ad9581 | Arturo Duarte]] |
| + | |- |
| + | | [[User:dannyblanchard | Danny Blanchard]] |
| + | | [[User:rtystgeeke | Andrew Camardella]] |
| |- | | |- |
| |} | | |} |
| | | |
| [[Category:Fabrication]] | | [[Category:Fabrication]] |