Line 2: |
Line 2: |
| |owner = PS:One | | |owner = PS:One |
| |serial = 5549 | | |serial = 5549 |
− | |certification = no | + | |certification = Yes |
− | |hackable = yes | + | |hackable = Consult CNC Area Host |
| |model = ShapeOko 2 "The Works" version | | |model = ShapeOko 2 "The Works" version |
| |arrived = 2014 | | |arrived = 2014 |
Line 11: |
Line 11: |
| |value = $1000 | | |value = $1000 |
| |image = Shapeoko2.JPG | | |image = Shapeoko2.JPG |
− | |hostarea = Cold Metals | + | |hostarea = Industrial CNC |
| }} | | }} |
| | | |
| == Status == | | == Status == |
− | Operational as of Feb 23 2018.
| + | Under construction. |
| + | |
| + | Tuning, authorization path, and documentation are all being redeveloped as of February 24th, 2020. |
| | | |
| == Authorization == | | == Authorization == |
Line 52: |
Line 54: |
| ** If the bit is too deep in the collet, it can bottom out inside the spindle when you begin to tighten the collet. | | ** If the bit is too deep in the collet, it can bottom out inside the spindle when you begin to tighten the collet. |
| * Use 14mm wrenches (in the black bag) to tighten the collet. You don't need to over-tighten the collet - hand tighten, not gorilla tighten. | | * Use 14mm wrenches (in the black bag) to tighten the collet. You don't need to over-tighten the collet - hand tighten, not gorilla tighten. |
| + | |
| + | ===Using Fusion 360=== |
| + | |
| + | You will need to install the Easel post processor in order to get usable GCode from Fusion 360 to the Shapeoko. The post processor is available here: |
| + | |
| + | https://cam.autodesk.com/hsmposts?p=easel |
| + | |
| + | When using Universal GCode Sender, you will get a "HOLD" error because it leads with a tool change (M6). The Shapeoko does not support a tool change command, and so simply hitting the "Play" button again will resume operation. |
| | | |
| === Carving with Easel === | | === Carving with Easel === |
Line 183: |
Line 193: |
| |[[User:bbay | Brandon Bay]] | | |[[User:bbay | Brandon Bay]] |
| | Jim Brink | | | Jim Brink |
| + | |- |
| + | |[[User:Amethystdragon | Karl Schmidbauer]] |
| + | | Mike Thompson |
| |- | | |- |
| |} | | |} |