14
edits
Changes
Jump to navigation
Jump to search
Line 54:
Line 54: + + + + + + + + Line 185:
Line 193: + + +
no edit summary
** If the bit is too deep in the collet, it can bottom out inside the spindle when you begin to tighten the collet.
** If the bit is too deep in the collet, it can bottom out inside the spindle when you begin to tighten the collet.
* Use 14mm wrenches (in the black bag) to tighten the collet. You don't need to over-tighten the collet - hand tighten, not gorilla tighten.
* Use 14mm wrenches (in the black bag) to tighten the collet. You don't need to over-tighten the collet - hand tighten, not gorilla tighten.
===Using Fusion 360===
You will need to install the Easel post processor in order to get usable GCode from Fusion 360 to the Shapeoko. The post processor is available here:
https://cam.autodesk.com/hsmposts?p=easel
When using Universal GCode Sender, you will get a "HOLD" error because it leads with a tool change (M6). The Shapeoko does not support a tool change command, and so simply hitting the "Play" button again will resume operation.
=== Carving with Easel ===
=== Carving with Easel ===
|[[User:bbay | Brandon Bay]]
|[[User:bbay | Brandon Bay]]
| Jim Brink
| Jim Brink
|-
|[[User:Amethystdragon | Karl Schmidbauer]]
| Mike Thompson
|-
|-
|}
|}