Domain Admins
763
edits
Changes
Jump to navigation
Jump to search
Line 53:
Line 53: − +
→Carving with Easel
* Click carve.
* Click carve.
* Turn on the machine by pulling up on the button.
* Turn on the machine by pulling up on the button.
* Click Unlock Without Homing. ("Home Machine" will send the machine to where it thinks is home.)
* Click "Unlock Without Homing." ("Home Machine" will send the machine to where it thinks is home.)
* Home the machine: align the endmill with the bottom left corner of the workpiece (or wherever you want to set as home). Bring the bit down to just touch the workpiece.
* Home the machine: align the endmill with the bottom left corner of the workpiece (or wherever you want to set as home). Bring the bit down to just touch the workpiece.
** (You will need to reset the Z every operation. The machine loses Z calibration after each run, though it keeps XY home information.)
** (You will need to reset the Z every operation. The machine loses Z calibration after each run, though it keeps XY home information.)