Difference between revisions of "Shop Fox 8" Plate Shear"
Jump to navigation
Jump to search
| (9 intermediate revisions by 6 users not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Template:EquipmentPage | ||
| + | | owner = Michael Skilton | ||
| + | | model = M1040 | ||
| + | | doesitwork = yes | ||
| + | | contact = Michael Skilton | ||
| + | | where = | ||
| + | | certification = No | ||
| + | | hackable = No | ||
| + | | value = $100 | ||
| + | | arrived = 2013 | ||
| + | |image = Shop Fox plate shear.jpg | ||
| + | }} | ||
| + | = Removed by owner 3/13/20 = | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
== Note == | == Note == | ||
| − | |||
Primarily designed for straight cuts in sheet metal. | Primarily designed for straight cuts in sheet metal. | ||
| Line 34: | Line 31: | ||
| − | + | [[Category:Retired Equipment]] | |
| − | |||
| − | [[Category: | ||
| − | |||
| − | |||
Latest revision as of 21:49, 13 March 2020
 | |
| Owner/Loaner | Michael Skilton |
|---|---|
| Serial Number | {{{serial}}} |
| Make/Model | M1040 |
| Arrival Date | 2013 |
| Usability | yes |
| Contact | Michael Skilton |
| Authorization Needed | No |
| Hackable | No |
| Estimated Value | $100 |
| Host Area | {{{hostarea}}} |
Removed by owner 3/13/20
Note
Primarily designed for straight cuts in sheet metal.
Nothing harder then mild steel.
The knurled knob is meant to be a clamp and is helpful for thicker materials.
Flat stock only on the blades, No channel or angle etc.
No rod or wire except in the hole.
It will cut 1/8 mild steel and 1/2" rod but I recommend 12 gauge sheet and 3/8 diameter as maximums.
Pull slowly and be prepared for a jolt if you are pulling hard at the end of a cut.