Difference between revisions of "Shop Fox 8" Plate Shear"
Jump to navigation
Jump to search
(Created page with 'Back to list of Equipment Contents [hide] 1 Label 2 General 3 Note == Label == {{Template:EquipmentLabel|owner= Michael Skilton |certification={{{no}}}|hackabl…') |
|||
| Line 22: | Line 22: | ||
Estimated Value: $100 | Estimated Value: $100 | ||
| − | + | ||
| + | == Note == | ||
| + | |||
Primarily designed for straight cuts in sheet metal. | Primarily designed for straight cuts in sheet metal. | ||
Revision as of 17:51, 2 April 2013
Back to list of Equipment Contents [hide]
1 Label 2 General 3 Note
Label
Owner/Loaner: Michael Skilton Serial Number: Make/Model: M1040 Arrival Date: 2013 Usability: Working Contact: Michael Skilton Where: Machine Shop Certification Needed: No Hackable: No Estimated Value: $100
Note
Primarily designed for straight cuts in sheet metal.
Nothing harder then mild steel.
The knurled knob is meant to be a clamp and is helpful for thicker materials.
Flat stock only on the blades, No channel or angle etc.
No rod or wire except in the hole.
It will cut 1/8 mild steel and 1/2" rod but I recommend 12 gauge sheet and 3/8 diameter as maximums.
Pull slowly and be prepared for a jolt if you are pulling hard at the end of a cut.
Categories: Shop Equipment | Metalworking | Equipment