Line 70: |
Line 70: |
| | | |
| [https://groups.google.com/forum/?fromgroups=#!searchin/pumping-station-one/shopbot Shopbot Forum] | | [https://groups.google.com/forum/?fromgroups=#!searchin/pumping-station-one/shopbot Shopbot Forum] |
| + | |
| + | [https://groups.google.com/d/msg/pumping-station-one/vUF3iKRQ9yc/_qNnLXzZ3QcJ Overvies of Cut Load calcualtions for setting bit feed and speed rates] |
| | | |
| == User Tips & Troubleshooting Reports == | | == User Tips & Troubleshooting Reports == |
Line 145: |
Line 147: |
| | | |
| * Collets, Bits, Feeds and Speeds | | * Collets, Bits, Feeds and Speeds |
| + | ** Feeds and Speeds |
| + | ***Use a Cut Load Calculator to determine which feeds and speeds you should be using for your specific bits. An overview is avaialble at: [https://groups.google.com/d/msg/pumping-station-one/vUF3iKRQ9yc/_qNnLXzZ3QcJ] |
| ** Collets | | ** Collets |
| *** We currently have collets for 1/2, 1/4, 3/16 and 1/8" shank bits. | | *** We currently have collets for 1/2, 1/4, 3/16 and 1/8" shank bits. |
Line 155: |
Line 159: |
| * ShopBot should not be used for... | | * ShopBot should not be used for... |
| ** Metals other than aluminum | | ** Metals other than aluminum |
− | ** Cutting anything that requires coolant or lubricant (it will wreck the waste board) | + | ** Cutting anything that requires coolant or lubricant (it will ruin the waste board) |
| ** Ripping lumber (use the table saw) | | ** Ripping lumber (use the table saw) |
| ** Thickness Planning (Use the planner if you can) | | ** Thickness Planning (Use the planner if you can) |