June 2017: There is an intermittent break in the wiring for the Z-axis Zero Plate. Check for continuity before using (the #1 input should light up on screen when you touch the contacts together). It usually works near the front of the table, but not halfway back. This will get fixed eventually, but it's a good idea to be in the habit of checking. | June 2017: There is an intermittent break in the wiring for the Z-axis Zero Plate. Check for continuity before using (the #1 input should light up on screen when you touch the contacts together). It usually works near the front of the table, but not halfway back. This will get fixed eventually, but it's a good idea to be in the habit of checking. |