15
edits
Changes
From Pumping Station One
mLine 113:
Line 113: − + − ***It is probably possible to put this on the Autodesk cloud and use it that way, but I don't know how. Help here would be appreciated.+ −
→Software Tool Chain
**The ShopBot computer does not have this and may not be fast enough to run it.
**The ShopBot computer does not have this and may not be fast enough to run it.
**You '''MUST''' use the custom post-processor below. Otherwise, you will bypass the safety check to make sure the spindle really is running!
**You '''MUST''' use the custom post-processor below. Otherwise, you will bypass the safety check to make sure the spindle really is running!
**For '''Windows''', to install this on your local computer:
**For local '''Windows''', to install this on your local computer:
***Unzip and install this in C:\Users\YourName\AppData\Roaming\Autodesk\Fusion 360 CAM\Posts
***Unzip and install this in C:\Users\YourName\AppData\Roaming\Autodesk\Fusion 360 CAM\Posts
***Note that AppData is often a hidden folder!
***Note that AppData is often a hidden folder!
***Inside Fusion 360, when you select Actions / Post Process, under Configuration Folder, hit Setup and select Use Personal Posts.
***Inside Fusion 360, when you select Actions / Post Process, under Configuration Folder, hit Setup and select Use Personal Posts.
**For local '''Mac'''
**For '''Mac'''
*** Unzip and install in Macintosh HD> Users> USERNAME> Autodesk> Fusion 360 CAM> Posts
*** Unzip and install in Macintosh HD> Users> USERNAME> Autodesk> Fusion 360 CAM> Posts
*** In Fusion 360, when you select Actions > Post Process, under Settings select Personal Posts for the Source
*** In Fusion 360, when you select Actions > Post Process, under Settings select Personal Posts for the Source
