137
edits
Changes
From Pumping Station One
Supermax 25x2 Drum Sander (view source)
Revision as of 14:25, 13 December 2023
, 14:25, 13 December 2023Asset removal notice added
|serial=?
|serial=?
|arrived=
|arrived=
|doesitwork=yes
|doesitwork=Yesu
|contact=[[user: ericbeau|Eric Beauchamp]]
|contact=[[user: samparis|Sam Paris]]
|where=Wood Shop
|where=Wood Shop
|certification=yes
|certification=yes
== Status ==
== Status ==
=Ths asset is being removed from PS:1=
Needs jamb nuts 1/6/2022
Aug 30 2018 Eric B installed new motor and starter capacitor..
Aug 30 2018 Eric B installed new motor and starter capacitor..
'''
'''
*For oily or dense woods (tropical hardwoods, etc), take only very light passes to prevent clogging the sandpaper.
*For oily or dense woods (tropical hardwoods, etc), take only very light passes to prevent clogging the sandpaper.
*Always remove dried glue squeeze outs with a scraper or other tool before coming here.
*DO NOT USE unless glue has fully dried
*Use a belt cleaner occasionally to refresh the sandpaper
*Use a belt cleaner occasionally to refresh the sandpaper
*Do not use to remove old finishes.
=== Abrasive Dimensions ===
If you need to cut a new abrasive from the roll and tracing the old one isn't convenient, use the dimensions below.
[[File:Supermax 25x2 abrasive dimension.png]]
(not to scale!)
# From one square cut edge, measure 12' and cut another square edge. You now have a strip of abrasive 144" long and 4" wide.
# Measure 13.5" from one end and make a mark on the back of the paper. Trace this line to the nearby end's opposite corner, making a diagonal. This 13 1/2" x 4" right triangle defines the first "tail." Cut along this diagonal to make the first end pointy.
# Measure 3.5" from the point. Draw a line perpendicular to the diagonal edge. Cut this off to make the pointy end stubby.
# Repeat this procedure on the other end **but on the opposite edge.** That is, make a (blunted) rhombus, not a trapezoid. You now have two tails on your long strip, one "facing up" and one "facing down."
# Refer to the video on how to install this into the machine.
== Safety ==
== Safety ==
