Aug 30 2018 Eric B installed new motor and starter capacitor..
Aug 30 2018 Eric B installed new motor and starter capacitor..
'''
'''
Line 42:
Line 47:
*Do not use to remove old finishes.
*Do not use to remove old finishes.
+
+
=== Abrasive Dimensions ===
+
+
If you need to cut a new abrasive from the roll and tracing the old one isn't convenient, use the dimensions below.
+
+
[[File:Supermax 25x2 abrasive dimension.png]]
+
(not to scale!)
+
+
# From one square cut edge, measure 12' and cut another square edge. You now have a strip of abrasive 144" long and 4" wide.
+
# Measure 13.5" from one end and make a mark on the back of the paper. Trace this line to the nearby end's opposite corner, making a diagonal. This 13 1/2" x 4" right triangle defines the first "tail." Cut along this diagonal to make the first end pointy.
+
# Measure 3.5" from the point. Draw a line perpendicular to the diagonal edge. Cut this off to make the pointy end stubby.
+
# Repeat this procedure on the other end **but on the opposite edge.** That is, make a (blunted) rhombus, not a trapezoid. You now have two tails on your long strip, one "facing up" and one "facing down."
+
# Refer to the video on how to install this into the machine.