Line 13: |
Line 13: |
| |hostarea=Wood Shop | | |hostarea=Wood Shop |
| }} | | }} |
| + | |
| + | |
| + | == Notes == |
| + | |
| + | *For oily or dense woods (tropical hardwoods, etc), take only very light passes to prevent clogging the sandpaper. |
| + | |
| + | *Use a belt cleaner occasionally to refresh the sandpaper |
| + | |
| + | == Safety == |
| + | |
| + | This sander features overload detection. If the machine detects too high a load, it will automatically slow down the feed. This saves wear and tear on the machine, but may cause burning of the workpiece if you cut too aggressively. |
| + | |
| + | *The height adjustment on this machine is VERY aggressive. A full turn will raise the table by more than 2mm (a typical cut should be < .5mm). '''PLEASE USE A MAXIMUM OF 1/8 TURN OF THE HEIGHT WHEEL PER PASS!''' |
| + | |
| + | * Make your first cuts with a very slow speed (10 or less). Once you are sure the load is OK you can gradually increase the speed on subsequent passes. |
| + | |
| + | *When overload detection kicks in, a red light next to the speed control will turn on. '''IF YOU SEE THIS LIGHT, PLEASE REDUCE YOUR DEPTH OF CUT AND/OR FEED RATE!''' |
| + | |
| + | *Like all of our other sanders, sleeves must be above the elbow, and no gloves should be worn. It's pretty easy to get pulled into the rollers. |
| + | |
| | | |
| == List of Currently Authorized Users == | | == List of Currently Authorized Users == |
Line 44: |
Line 64: |
| |9/7/17 | | |9/7/17 |
| |} | | |} |
− |
| |
− |
| |
− | == Notes ==
| |
− |
| |
− | *For oily or dense woods (tropical hardwoods, etc), take only very light passes to prevent clogging the sandpaper.
| |
− |
| |
− | *Use a belt cleaner occasionally to refresh the sandpaper
| |
− |
| |
− | == Safety ==
| |
− |
| |
− | This sander features overload detection. If the machine detects too high a load, it will automatically slow down the feed. This saves wear and tear on the machine, but may cause burning of the workpiece if you cut too aggressively.
| |
− |
| |
− | *The height adjustment on this machine is VERY aggressive. A full turn will raise the table by more than 2mm (a typical cut should be < .5mm). '''PLEASE USE A MAXIMUM OF 1/8 TURN OF THE HEIGHT WHEEL PER PASS!'''
| |
− |
| |
− | * Make your first cuts with a very slow speed (10 or less). Once you are sure the load is OK you can gradually increase the speed on subsequent passes.
| |
− |
| |
− | *When overload detection kicks in, a red light next to the speed control will turn on. '''IF YOU SEE THIS LIGHT, PLEASE REDUCE YOUR DEPTH OF CUT AND/OR FEED RATE!'''
| |
− |
| |
− | *Like all of our other sanders, sleeves must be above the elbow, and no gloves should be worn. It's pretty easy to get pulled into the rollers.
| |
| | | |
| | | |