3,430
edits
Changes
From Pumping Station One
Talk:Laser Cutter Instructions and Workflow (view source)
Revision as of 15:12, 6 November 2013
, 15:12, 6 November 2013→Configure Laser Settings >> Enable Auto Focus
== Configure Laser Settings >> Enable Auto Focus ==
Perhaps I am remembering incorrectly, but I think my trainer (Liz) told me that Auto Focus was not to be trusted, and that the laser should be manually focused every time?
Perhaps I am remembering incorrectly, but I think my trainer (Liz) told me that Auto Focus was not to be trusted, and that the laser should be manually focused every time?
--[[User:Jaypee|Jaypee]] ([[User talk:Jaypee|talk]]) 15:32, 5 November 2013 (CST)
--[[User:Jaypee|Jaypee]] ([[User talk:Jaypee|talk]]) 15:32, 5 November 2013 (CST)
=== Auto Focus Induced Head Crash ===
I heard some disagreement over auto focus when I was being certified, so it's reasonable that there'd be differing instructions scattered around. Given that the lazor was temporarily out of commission because of an autofocus-induced head crash and Liz is the CNC area host, I went ahead and changed the wording to say "Do '''not''' enable..". [[User:Negativek|Negativek]] ([[User talk:Negativek|talk]]) 15:48, 5 November 2013 (CST)
I heard some disagreement over auto focus when I was being certified, so it's reasonable that there'd be differing instructions scattered around. Given that the lazor was temporarily out of commission because of an autofocus-induced head crash and Liz is the CNC area host, I went ahead and changed the wording to say "Do '''not''' enable..". [[User:Negativek|Negativek]] ([[User talk:Negativek|talk]]) 15:48, 5 November 2013 (CST)
=== Better Cut Quality ===
We got better cuts with manual focus over auto focus, enough to make a pretty significant difference.
--[[User:Hef|Hef]] ([[User talk:Hef|talk]]) 09:12, 6 November 2013 (CST)
