Difference between revisions of "Talk:Laser Cutter Instructions and Workflow"
Jump to navigation
Jump to search
(Question re: auto focus) |
|||
| Line 1: | Line 1: | ||
| − | + | === Configure Laser Settings >> Enable Auto Focus === | |
Perhaps I am remembering incorrectly, but I think my trainer (Liz) told me that Auto Focus was not to be trusted, and that the laser should be manually focused every time? | Perhaps I am remembering incorrectly, but I think my trainer (Liz) told me that Auto Focus was not to be trusted, and that the laser should be manually focused every time? | ||
--[[User:Jaypee|Jaypee]] ([[User talk:Jaypee|talk]]) 15:32, 5 November 2013 (CST) | --[[User:Jaypee|Jaypee]] ([[User talk:Jaypee|talk]]) 15:32, 5 November 2013 (CST) | ||
| + | |||
| + | I heard some disagreement over auto focus when I was being certified, so it's reasonable that there'd be differing instructions scattered around. Given that the lazor was temporarily out of commission because of an autofocus-induced head crash and Liz is the CNC area host, I went ahead and changed the wording to say "Do '''not''' enable..". [[User:Negativek|Negativek]] ([[User talk:Negativek|talk]]) 15:48, 5 November 2013 (CST) | ||
Revision as of 21:48, 5 November 2013
Configure Laser Settings >> Enable Auto Focus
Perhaps I am remembering incorrectly, but I think my trainer (Liz) told me that Auto Focus was not to be trusted, and that the laser should be manually focused every time? --Jaypee (talk) 15:32, 5 November 2013 (CST)
I heard some disagreement over auto focus when I was being certified, so it's reasonable that there'd be differing instructions scattered around. Given that the lazor was temporarily out of commission because of an autofocus-induced head crash and Liz is the CNC area host, I went ahead and changed the wording to say "Do not enable..". Negativek (talk) 15:48, 5 November 2013 (CST)