577
edits
Changes
From Pumping Station One
Tormach 1300PL CNC Plasma Cutter (view source)
Revision as of 16:39, 3 January 2023
, 16:39, 3 January 2023→Description
== Description ==
== Description ==
Will fill this in later.
Will fill this in later.
== Maintenance ==
(Shamelessly copied from page 58 in the manual)
=== Daily ===
* Clean the machine of any dust or abrasive particle buildup with a vacuum and brushes.
* Wipe dust off of the linear rails with a clean cloth.
=== Weekly ===
* Clean all exterior surfaces with a mild cleaner.
* Examine the water table's level and, if necessary, add water / rust inhibitor (GreenCut).
* Check your plasma torch consumables for wear and replace if needed.
=== Monthly ===
* Clean the electrical cabinet vents of dust with a clean cloth or compressed air.
* Remove the slats and clean sediment buildup from the bottom of the water table.
=== Semi-Annually ===
* Check drive belts for wear and re-tension if needed.
* Remove faceplate from torch lifter and clean lead screw with a lint-free cloth.
== Status ==
== Status ==
