425
edits
Changes
From Pumping Station One
mLine 43:
Line 43: − <br/>+ − <br/>+ Line 55:
Line 55: − <br/>+
no edit summary
Click the X,Y & Z Zero buttons.<br/>
Click the X,Y & Z Zero buttons.<br/>
Select your material using the auto F&S selector drop downs. Note the amps required setting in the pop up window.<br/>
Select your material using the auto F&S selector drop downs. Note the amps required setting in the pop up window.<br/>
==== Hypertherm Plasma setup ====
==== Hypertherm Plasma setup ====
Turn on Hypertherm machine at the back of the Tormach, you should see three green lights.<br/>
Turn on Hypertherm machine at the back of the Tormach, you should see three green lights.<br/>
Check that Hypertherm Amps setting matches the amps required setting in the Pathpilot pop up window, adjust as necessary.<br/>
Check that Hypertherm Amps setting matches the amps required setting in the Pathpilot pop up window, adjust as necessary.<br/>
==== Run your job ====
==== Run your job ====
If you haven’t already, load your Gcode, click the reset button if flashing.<br/>
If you haven’t already, load your Gcode, click the reset button if flashing.<br/>
Run Job. Click cycle start.<br/>
Run Job. Click cycle start.<br/>
*Be prepared to click stop or hit Estop if something seems wrong*<br/>
*Be prepared to click stop or hit Estop if something seems wrong*<br/>
==== Shut Down ====
==== Shut Down ====
Set the Hypertherm plasma to 45 amps if needed and turn off the machine.<br/>
Set the Hypertherm plasma to 45 amps if needed and turn off the machine.<br/>
