Difference between revisions of "Wood Shop Dust Collection Design Notes"
(Created page with "Design Guidelines for Clearview Dust Collector Inlet port on dust collector is angled up at 11 degrees. To reduce turbulence in the collector, first 5 feet should be strai...") |
|||
Line 19: | Line 19: | ||
Clearvue order: | Clearvue order: | ||
− | CVMAX 3 phase | + | CVMAX 3 phase with filters with nano filter upgrade $1870+100 |
− | + | filter clean out box $80 | |
− | + | quantity:6 6" blast gates $15 each | |
− | + | DC1100 Pro Air Quality Monitor with PC interface $289.99 | |
− | + | Discount code for 5% off: CVCFAN |
Revision as of 18:59, 4 June 2014
Design Guidelines for Clearview Dust Collector
Inlet port on dust collector is angled up at 11 degrees.
To reduce turbulence in the collector, first 5 feet should be straight with no fittings.
Put down drop blast gates as close to the main duct as possible.
Use SRD-35 or ASTN D3034 PVC or 24 gauge spiral duct or thicker.
Two 45 degree elbows has lower resistance than a single 90. Putting a short piece of straight pipe between the 45s is best.
3 phase motor is 99 pounds.
Use at least 5" port on machines for best results.
Clearvue blast gates are sized for PVC pipe.
Clearvue order:
CVMAX 3 phase with filters with nano filter upgrade $1870+100
filter clean out box $80
quantity:6 6" blast gates $15 each
DC1100 Pro Air Quality Monitor with PC interface $289.99
Discount code for 5% off: CVCFAN