Domain Admins
44
edits
Changes
From Pumping Station One
Wood Shop Dust Collection Design Notes (view source)
Revision as of 07:16, 24 April 2015
, 07:16, 24 April 2015add laser cuttable template
The approximate dimensions of the rack are 44" wide x 33" deep x 8.5' tall. Dimensions of the collector without the inlet tube are approximately 24"x34"x8'. (is this also true for the nano filter?)
The approximate dimensions of the rack are 44" wide x 33" deep x 8.5' tall. Dimensions of the collector without the inlet tube are approximately 24"x34"x8'. (is this also true for the nano filter?)
Inlet port on dust collector is angled up at 11 degrees.
Inlet port on dust collector is angled up at 11 degrees
3 phase motor is 99 pounds.
3 phase motor is 99 pounds.
The collector is up and mounted. The joint between the blower housing and the cyclone needs to be caulked ( which may require dropping the cyclone a few inches).
The collector is up and mounted. The joint between the blower housing and the cyclone needs to be caulked ( which may require dropping the cyclone a few inches).
== Ducting ==
== Ducting ==
To reduce turbulence in the collector, first 5 feet should be straight with no fittings.
To reduce turbulence in the collector, first 5 feet should be straight with no fittings.
Put down drop blast gates as close to the main duct as possible.
Put down [[File:Blast_gate.doc]][[File:Blast_gate_front.svg]][[File:Blast_gate_back.svg]] as close to the main duct as possible.
Clearvue: Use SRD-35 or ASTN D3034 PVC or 24 gauge spiral duct or thicker.
Clearvue: Use SRD-35 or ASTN D3034 PVC or 24 gauge spiral duct or thicker.
Order 6" flexible hose for shopbot.
Order 6" flexible hose for shopbot.
Upper table saw guard/collector from Shark Guard has a 4 month lead time. We need to find another supplier or fabricate one.
Upper table saw guard/collector from Shark Guard has a 4 month lead time. We need to find another supplier or fabricate one.
Buy or make a collector shoe for the shopbot. The shoe supplied with the shopbot has a very small inlet (3.5"?). It will probably work for the short term.
Buy or make a collector shoe for the shopbot. The shoe supplied with the shopbot has a very small inlet (3.5"?). It will probably work for the short term.
find 2 conductor cable and switches for the motor control. Power supply for the SSR (12-36v?).
find 2 conductor cable and switches for the motor control. Power supply for the SSR (12-36v?).
Install ducting. Duct order should arrive 7/10.
Install ducting. Duct order should arrive 7/10.
Make hoods for chopsaw and planer.
Make hoods for chopsaw and planer.
