WikiBots
1,397
edits
Changes
From Pumping Station One
Wood Shop Dust Collection Design Notes (view source)
Revision as of 14:01, 5 June 2014
, 14:01, 5 June 2014Robot: Cosmetic changes
Design Guidelines for Clearview Dust Collector
Design Guidelines for Clearview Dust Collector
Install the collector in the pallet rack behind the Shopbot. This will make the mounting of the motor easy and provide a framework for a sound enclosure, if it is necessary. The approximate dimensions of the rack are 44" wide x 33" deep x 9' tall.
Install the collector in the pallet rack behind the Shopbot. This will make the mounting of the motor easy and provide a framework for a sound enclosure, if it is necessary. The approximate dimensions of the rack are 44" wide x 33" deep x 9' tall.
Inlet port on dust collector is angled up at 11 degrees.
Inlet port on dust collector is angled up at 11 degrees.
To reduce turbulence in the collector, first 5 feet should be straight with no fittings.
To reduce turbulence in the collector, first 5 feet should be straight with no fittings.
Use SRD-35 or ASTN D3034 PVC or 24 gauge spiral duct or thicker.
Use SRD-35 or ASTN D3034 PVC or 24 gauge spiral duct or thicker.
Two 45 degree elbows has lower resistance than a single 90. Putting a short piece of straight pipe between the 45s is best.
Two 45 degree elbows has lower resistance than a single 90. Putting a short piece of straight pipe between the 45s is best.
3 phase motor is 99 pounds.
3 phase motor is 99 pounds.
