*If available, attach a ShopVac hose to rear dust port on the table to collect sawdust during use.
*If available, attach a ShopVac hose to rear dust port on the table to collect sawdust during use.
−
*Adjust the height of the router with a (MEASURE AND FILL IN) hex key. Do not use the wrong size key for the height adjustment.
+
*Adjust the height of the router with a 6mm hex key. Do not use the wrong size key for the height adjustment.
*Ensure the bit can spin freely and does not catch the fence prior to making your cut.
*Ensure the bit can spin freely and does not catch the fence prior to making your cut.
Line 121:
Line 121:
*The height gauge on this tool is no longer accurate - always check the height of the cutter head relative to your workpiece before beginning a cut.
*The height gauge on this tool is no longer accurate - always check the height of the cutter head relative to your workpiece before beginning a cut.
−
*Do not plane pieces thinner than 1/4" or shorter than the length of the cutting area. Your work piece should be sticking out of one end of the planer during the whole pass.
+
*Do not plane pieces thinner than 1/4" or shorter than the length of the cutting area (from roller to roller). Your work piece should be sticking out of one end of the planer during the whole pass.