483
edits
Changes
Jump to navigation
Jump to search
Line 22:
Line 22: − +
Laser Cutter Instructions and Workflow (view source)
Revision as of 16:22, 19 May 2014
, 16:22, 19 May 2014Make job type list the same order as the explanations
* Click “Setup”.
* Click “Setup”.
* Click “Preferences”.
* Click “Preferences”.
* Choose the job type: “Raster”, “Vector”, or “Combined” based on if you are cutting, etching, or doing both. If you have a Raster or Combined job, set the resolution appropriately, but generally there’s no need to go above 600dpi.
* Choose the job type: “Raster”, “Vector”, or “Combined” based on if you are etching, cutting, or doing both. If you have a Raster or Combined job, set the resolution appropriately, but generally there’s no need to go above 600dpi.
* Do '''not''' enable Auto Focus.
* Do '''not''' enable Auto Focus.
* Set the piece size accordingly, or just set to 24” by 12” and set the art board within the vector application to 24” by 12” and then position the cutting/engraving image within the art board in).
* Set the piece size accordingly, or just set to 24” by 12” and set the art board within the vector application to 24” by 12” and then position the cutting/engraving image within the art board in).