Domain Admins
586
edits
Changes
Jump to navigation
Jump to search
Line 18:
Line 18: − − * Obsolete 12/10/16 One phase of the starter is working intermittently. We cleaned the contacts of the starter, but this didn't fix the problem. If the motor is making noise and not turning, turn the starter on the back of the saw 'off' and then 'on. If the problem persists, leave the saw off. We should replace the starter.
→Status
Open Tasks: 1. Label control box 2. Modify gear cover or fabricate new one. 3. Wire end-of-cut switch to control box.
Open Tasks: 1. Label control box 2. Modify gear cover or fabricate new one. 3. Wire end-of-cut switch to control box.
- Jim Brink 12/10/16
- Jim Brink 12/10/16
* The large groove (fastest speed) of the motor shaft step pulley is bent. The motor vibrates excessively when the belt is in this groove. Use the other grooves (slower speeds) until the pulley is replaced.
* The large groove (fastest speed) of the motor shaft step pulley is bent. The motor vibrates excessively when the belt is in this groove. Use the other grooves (slower speeds) until the pulley is replaced.