Changes

*Always open the dust collector gate and turn on the dust collector prior to working with the table saw. Close the gate when done.

*Always open the dust collector gate and turn on the dust collector prior to working with the table saw. Close the gate when done.

*This saw has a built-in safety brake that will trigger when contact is made with flesh or conductive material. DO NOT CUT THE FOLLOWING ON THIS SAW:

*This saw has a built-in safety brake that will trigger when contact is made with flesh or conductive material. Check your material for metal pieces using the metal detector. DO NOT CUT THE FOLLOWING ON THIS SAW:

**Mirrored acrylic

**Mirrored acrylic

**Laser cut pieces (the black carbon residue is conductive)

**Laser cut pieces (the black carbon residue is conductive)

**Any other conductive materials

**Any other conductive materials

*Use a cross-cut sled (preferable) or miter gauge when making cross-cuts or miter cuts. Do not use the fence when using a cross-cut sled or miter gauge. Generally, a cross-cut sled or miter gauge should be used if the longest edge of the piece can't be supported on the fence.

*Use a cross-cut sled or miter gauge when making cross-cuts or miter cuts. Do not use the fence when using a cross-cut sled or miter gauge. Generally, a cross-cut sled or miter gauge should be used if the longest edge of the piece can't be supported on the fence.

*Stand to the side of the blade when cutting - do not stand directly behind the blade in the line of kickback.

*Stand to the side of the blade when cutting - do not stand directly behind the blade in the line of kickback.

*If you cannot hold the piece firmly when cutting, ask for help. Use push-sticks if necessary.

*If you cannot hold the piece firmly when cutting, ask for help. Use push-sticks if necessary. Hold the workpiece firmly against the fence or miter gauge during the entire cut.

*Clean up the work area when you're done!

*Clean up the work area when you're done!