7
edits
Changes
Jump to navigation
Jump to search
Line 23:
Line 23: + +
→Spindle Speed
Perhaps the fact that this can be done via console means that it could also be added to Gcode files by the post-processor? I'm not really sure. I did just notice this, though, a bit lower down in the FAQ:
Perhaps the fact that this can be done via console means that it could also be added to Gcode files by the post-processor? I'm not really sure. I did just notice this, though, a bit lower down in the FAQ:
If the VFD isn't reflecting the RPMs set in the control window, clos SB3, backup and delete shopbot.ini in "C:\ProgramData\ShopBot\ShopBot 3". Reload SB3 and it should work.
'''I want the RPM Control Window to open every time I start ShopBot 3'''
'''I want the RPM Control Window to open every time I start ShopBot 3'''