5
edits
Changes
Jump to navigation
Jump to search
Consew 287RB Industrial Sewing Machine (view source)
Revision as of 16:26, 17 August 2021
, 16:26, 17 August 2021Created page with "{{Template:EquipmentPage |image= |owner=PS:One|model=287rb |serial=|arrived= |doesitwork=yes |contact=Lydia Miller |where=Graphic Arts and Textiles |certification=yes |ha..."
{{Template:EquipmentPage
|image=
|owner=PS:One|model=287rb
|serial=|arrived=
|doesitwork=yes
|contact=Lydia Miller
|where=[[Graphic Arts and Textiles]]
|certification=yes
|hackable=no
|value=>$500
|hostarea=Arts
}}
== Documentation ==
Manual: https://manualzz.com/doc/54037058/consew-287rb-manual
Bobbin Winder: https://www.youtube.com/watch?v=OpicH93tcZ0
Insert Bobbin: https://www.youtube.com/watch?v=aur4-kMDu3s&list=FLjJ0tEj5of-FQYZzMHkevug&index=7
== Tips ==
* To reverse, pull the lever down
* To change stitch length, move the lever down and tighten screw to hold the lever in place
* To change the thread, it's easiest to cut the thread from the old feed and tie the new thread to it, then run the machine for a few seconds as the thread works it way through the loops.
== Troubleshooting ==
If you are having trouble getting the needle to properly catch on the bobbin thread, check the following:
* is the bobbin properly installed and threaded
* is the needle facing the right direction
* is the thread leading to the needle properly configured (missing some of the thread loops can result in a failure for the needle to properly catch the bobbin thread)
[[Category:Textiles]]
[[Category:Arts]]
|image=
|owner=PS:One|model=287rb
|serial=|arrived=
|doesitwork=yes
|contact=Lydia Miller
|where=[[Graphic Arts and Textiles]]
|certification=yes
|hackable=no
|value=>$500
|hostarea=Arts
}}
== Documentation ==
Manual: https://manualzz.com/doc/54037058/consew-287rb-manual
Bobbin Winder: https://www.youtube.com/watch?v=OpicH93tcZ0
Insert Bobbin: https://www.youtube.com/watch?v=aur4-kMDu3s&list=FLjJ0tEj5of-FQYZzMHkevug&index=7
== Tips ==
* To reverse, pull the lever down
* To change stitch length, move the lever down and tighten screw to hold the lever in place
* To change the thread, it's easiest to cut the thread from the old feed and tie the new thread to it, then run the machine for a few seconds as the thread works it way through the loops.
== Troubleshooting ==
If you are having trouble getting the needle to properly catch on the bobbin thread, check the following:
* is the bobbin properly installed and threaded
* is the needle facing the right direction
* is the thread leading to the needle properly configured (missing some of the thread loops can result in a failure for the needle to properly catch the bobbin thread)
[[Category:Textiles]]
[[Category:Arts]]