425
edits
Changes
Jump to navigation
Jump to search
Created page with 'Back to list of Equipment Contents [hide] 1 Label 2 General 3 Note == Label == {{Template:EquipmentLabel|owner= Michael Skilton |certification={{{no}}}|hackabl…'
Back to list of Equipment
Contents
[hide]
1 Label
2 General
3 Note
== Label ==
{{Template:EquipmentLabel|owner= Michael Skilton |certification={{{no}}}|hackable={{{no}}}}}
Owner/Loaner: Michael Skilton
Serial Number:
Make/Model: M1040
Arrival Date: 2013
Usability: Working
Contact: Michael Skilton
Where: Machine Shop
Certification Needed: No
Hackable: No
Estimated Value: $100
[edit] Note
Primarily designed for straight cuts in sheet metal.
Nothing harder then mild steel.
The knurled knob is meant to be a clamp and is helpful for thicker materials.
Flat stock only on the blades, No channel or angle etc.
No rod or wire except in the hole.
It will cut 1/8 mild steel and 1/2" rod but I recommend 12 gauge sheet and 3/8 diameter as maximums.
Pull slowly and be prepared for a jolt if you are pulling hard at the end of a cut.
Categories: Shop Equipment | Metalworking | Equipment
Contents
[hide]
1 Label
2 General
3 Note
== Label ==
{{Template:EquipmentLabel|owner= Michael Skilton |certification={{{no}}}|hackable={{{no}}}}}
Owner/Loaner: Michael Skilton
Serial Number:
Make/Model: M1040
Arrival Date: 2013
Usability: Working
Contact: Michael Skilton
Where: Machine Shop
Certification Needed: No
Hackable: No
Estimated Value: $100
[edit] Note
Primarily designed for straight cuts in sheet metal.
Nothing harder then mild steel.
The knurled knob is meant to be a clamp and is helpful for thicker materials.
Flat stock only on the blades, No channel or angle etc.
No rod or wire except in the hole.
It will cut 1/8 mild steel and 1/2" rod but I recommend 12 gauge sheet and 3/8 diameter as maximums.
Pull slowly and be prepared for a jolt if you are pulling hard at the end of a cut.
Categories: Shop Equipment | Metalworking | Equipment