Difference between revisions of "Shop Fox 8" Plate Shear"
Jump to navigation
Jump to search
m |
|||
Line 30: | Line 30: | ||
[[Category:Fabrication]] | [[Category:Fabrication]] | ||
[[Category:Cold Metals]] | [[Category:Cold Metals]] | ||
+ | [[Category:Loaned Equipment]] |
Revision as of 16:49, 16 August 2017
Note
Primarily designed for straight cuts in sheet metal.
Nothing harder then mild steel.
The knurled knob is meant to be a clamp and is helpful for thicker materials.
Flat stock only on the blades, No channel or angle etc.
No rod or wire except in the hole.
It will cut 1/8 mild steel and 1/2" rod but I recommend 12 gauge sheet and 3/8 diameter as maximums.
Pull slowly and be prepared for a jolt if you are pulling hard at the end of a cut.