Difference between revisions of "Supermax 25x2 Drum Sander"
Jump to navigation
Jump to search
m (Added authorized users list.) |
|||
Line 68: | Line 68: | ||
*[http://www.supermaxtools.com/products/wood/25x2-double-drum-sander Manufacturer's Page] | *[http://www.supermaxtools.com/products/wood/25x2-double-drum-sander Manufacturer's Page] | ||
*[http://www.supermaxtools.com/wp-content/uploads/25x2_37x2-10-2015.pdf Owner's Manual] | *[http://www.supermaxtools.com/wp-content/uploads/25x2_37x2-10-2015.pdf Owner's Manual] | ||
+ | |||
+ | = List of Currently Certified Users = | ||
+ | {| class="wikitable" border="1" | ||
+ | ! Qualified Member Keon Turner | ||
+ | ! Trained By Ron Olson | ||
+ | ! Date Certified | ||
+ | |- | ||
+ | |[[User:Ekaj|Jake Snyder]] | ||
+ | |Ralph Brendler | ||
+ | |9/7/17 | ||
+ | |} |
Revision as of 00:39, 11 September 2017
Owner/Loaner | PS:One |
---|---|
Serial Number | ? |
Make/Model | 25x2 |
Usability | yes |
Contact | Eric Beauchamp |
Where | Wood Shop |
Authorization Needed | yes |
Hackable | no |
Estimated Value | $2700 |
Host Area | Wood Shop |
Qualified Member | Trained By | Date |
---|---|---|
Eric Beauchamp | Danger committee | 6/23/2017 |
Ralph Brendler | Danger committee | 6/23/2017 |
Paul van Lake | Danger committee | 6/23/2017 |
Zack Sasnow | Jason Shanfield | 8/27/17 |
Justin Pestka | Ralph Brendler | 8.30.17 |
Notes
- For oily or dense woods (tropical hardwoods, etc), take only very light passes to prevent clogging the sandpaper.
- Use a belt cleaner occasionally to refresh the sandpaper
Safety
This sander features overload detection. If the machine detects too high a load, it will automatically slow down the feed. This saves wear and tear on the machine, but may cause burning of the workpiece if you cut too aggressively.
- The height adjustment on this machine is VERY aggressive. A full turn will raise the table by more than 2mm (a typical cut should be < .5mm). PLEASE USE A MAXIMUM OF 1/8 TURN OF THE HEIGHT WHEEL PER PASS!
- Make your first cuts with a very slow speed (10 or less). Once you are sure the load is OK you can gradually increase the speed on subsequent passes.
- When overload detection kicks in, a red light next to the speed control will turn on. IF YOU SEE THIS LIGHT, PLEASE REDUCE YOUR DEPTH OF CUT AND/OR FEED RATE!
- Like all of our other sanders, sleeves must be above the elbow, and no gloves should be worn. It's pretty easy to get pulled into the rollers.
Outside Links
List of Currently Certified Users
Qualified Member Keon Turner | Trained By Ron Olson | Date Certified |
---|---|---|
Jake Snyder | Ralph Brendler | 9/7/17 |