Line 6: |
Line 6: |
| * [[User:mct/wiki-todo|wiki cleanup]] | | * [[User:mct/wiki-todo|wiki cleanup]] |
| * [[User:mct/flammables-cabinet-cleanup|flammables cabinet cleanup]] | | * [[User:mct/flammables-cabinet-cleanup|flammables cabinet cleanup]] |
| + | |
| + | == outdated == |
| + | ''archived project pages that are no longer relevant to the current state of the shop'' |
| + | |
| + | * [[User:Mct/surface-grinder-setup-todo|surface grinder setup]] (''surface grinder is up & running'') |
| | | |
| = things = | | = things = |
Line 12: |
Line 17: |
| * 7/16" square drive handle for [[Clausing Lathe|clausing]] saddle lock | | * 7/16" square drive handle for [[Clausing Lathe|clausing]] saddle lock |
| ** get an appropriate socket, make a handle, and attach the two | | ** get an appropriate socket, make a handle, and attach the two |
| + | ** ''saddle lock square bolt head fits a 7/16" open wrench, but not the closed end, or a 7/16" 'universal' socket'' |
| + | ** ''a 1/2" 'universal' socket (or closed-end wrench) fits fine, if a little loosely'' |
| * magnetic whiteboard 'last organized' charts | | * magnetic whiteboard 'last organized' charts |
| ** can be affixed to cabinets / tool carts / shelves to show little charts of when they were last thoroughly organized | | ** can be affixed to cabinets / tool carts / shelves to show little charts of when they were last thoroughly organized |
| ** idea is to provide a decentralized, low-overhead means of coordinating contents organization / cleanup | | ** idea is to provide a decentralized, low-overhead means of coordinating contents organization / cleanup |
| + | * modular table covers for the bridgeport |
| + | ** modules |
| + | *** idea is to have them be in sections of 4-10" so they can accommodate the vice moving, &c |
| + | **** make multiple sizes, so they can be rearranged? |
| + | *** will need at least two special ones to fit snugly against vice sides, which aren't square |
| + | *** should have magnets in, so they stick to the table |
| + | *** blocks that fit (loosely?) into the t-slots, so they register easily |
| + | ** manufacture |
| + | *** will have to laser-cut, to get the contours for the vice-hugging sections right |
| + | *** engrave holes for magnets & mark out t-slot block positions |
| + | *** screw / glue / staple t-slot blocks down? |
| + | **** top surface should be flat, so would need to countersink screws carefully |
| + | ** material |
| + | *** maso or mdf would be easiest |
| + | *** plastic (hdpe?) for wear / oil resistence? |
| + | * convert one of the two spindexers into a powered cylindrical grinding fixture for the [[Boyer Schultz 6-12 Surface Grinder|surface grinder]] |
| + | ** mount motor, add round belt pulley to spindle |
| + | ** add thrust bearing to preload spindle |
| + | ** big thick base so the spindexer doesn't need to sit in the middle of the mag chuck |
| + | ** will probably need to make a pin spanner to tighten the front screw on |
| + | * tool height gauge for the [[Clausing Lathe|clausing]] |
| + | ** mag base to make it easy to mount solidly on the ways? |
| + | ** use dowel pin for reference surface |
| + | *** grind to proper dimension |
| + | ** need good way to experimentally determine proper tool height |