Difference between revisions of "Tormach CNC Plasma Cutter Debugging"
Jump to navigation
Jump to search
Makelemonade (talk | contribs) (Debug courtesy of tachonight/Ron Olson on #hotmetalshop slack) |
(No difference)
|
Revision as of 19:34, 2 May 2023
Message: *Button only permitted when machines is in state(s): referenced and idle, g-code program paused, g-code program running*
Check 1. Is the blue light on the button by the power switch? 2. Did you hit the reset button in pathpilot? 3. Does the torch move on the Z axis? 4. Is the "Machine OK" status light on? 5. Did you reference X, Y and Z?