54
edits
Changes
From Pumping Station One
→Auto Firing
After properly configuring the cables access to the interface can be found here: http://kilnpi.local:8081/ .
After properly configuring the cables access to the interface can be found here: http://kilnpi.local:8081/ .
When creating a profile make sure that your ramp rate is <8degF/minute.
[[File:KilnControllerSetup.png| center |Graphical User interface to kiln controller. Address is http://kilnpi.local:8081/ ]]
[[File:KilnControllerSetup.png| center |Graphical User interface to kiln controller. Address is http://kilnpi.local:8081/ ]]
Raspberry Pi zero can only connect to the 2.4 ghz network which requires your computer to do the same. To configure your machine to the 2.4ghz network you can follow this guide (windows): https://www.windowsdigitals.com/how-to-change-5ghz-to-2-4ghz-in-windows-10/
Raspberry Pi zero can only connect to the 2.4 ghz network which requires your computer to do the same. To configure your machine to the 2.4ghz network you can follow this guide (windows): https://www.windowsdigitals.com/how-to-change-5ghz-to-2-4ghz-in-windows-10/
===Kiln Example===
R&R Accelerated profile
[[File:KilnExample.png| center |Example run near of the accelerated profile. ]]
==Status==
==Status==
