425
edits
Changes
From Pumping Station One
Tormach CNC Plasma Cutter Debugging (view source)
Revision as of 12:34, 22 August 2023
, 12:34, 22 August 2023update
Check
Check
# Is the blue light on the button by the power switch?
# Did you hit the reset button in pathpilot?
# Does the torch move on the Z axis?
# Is the "Machine OK" status light on?
# Did you reference X, Y and Z?
Known issue with the MrFluffles post processor as of May 4 2023. Updated August 22, 2023
The post-processor is adding feed speed, cut height and a dwell command after the M200 command. This overrides the settings of the AutoFS stock picker in Pathpilot.
If you picked the correct tool/settings for your material in Sheetcam this shouldn't be an issue. However, using the same Gcode for different materials will likely lead to less-than-optimal cuts. The extra dwell after the pierce operation (G16) can be eliminated by setting the pierce delay in Sheetcam to zero.
