16
edits
Changes
From Pumping Station One
LulzBot AO-100 3D Printer (view source)
Revision as of 08:04, 30 January 2013
, 08:04, 30 January 2013→Operation
== Operation ==
== Operation ==
*Do not leave the printer unattended while printing*
Also, don't forget to turn the printer off when you are no longer using it.
=== Windows Drivers ===
=== Windows Drivers ===
Windows users will need to install drivers.
Windows users will need to install drivers.
Additionally, Lulzbot provides a [http://downloads.lulzbot.com/lulzbot/AO-100/software/2012-Q2/configs/slic3r/point5mm.ini slic3r config file] for the AO-100.
Additionally, Lulzbot provides a [http://downloads.lulzbot.com/lulzbot/AO-100/software/2012-Q2/configs/slic3r/point5mm.ini slic3r config file] for the AO-100.
=== Suggested Settings ===
Lulzbot's slic3r config has the infill density set at 0.75. Resulting prints are very sturdy as a result, but the filament consumption and print time go up because of this. It is recommended to turn it down to 0.15 or 0.25, and to increase the number of infill shells. Doing so should have a similar surface quality, but produce a print with significantly less mass.
=== Other Resources ===
=== Other Resources ===
