Difference between revisions of "48in sheet metal brake"
From Pumping Station One
(Dead link.) |
|||
(4 intermediate revisions by 2 users not shown) | |||
Line 6: | Line 6: | ||
|doesitwork=yes | |doesitwork=yes | ||
|contact=Dean Anderson (Area Host) | |contact=Dean Anderson (Area Host) | ||
− | |where= | + | |where=Cold Metals |
|certification=no | |certification=no | ||
|hackable=no | |hackable=no | ||
− | |value=$750.00}}<br /> | + | |value=$750.00 |
+ | |hostarea=Cold Metals | ||
+ | }}<br /> | ||
== Use == | == Use == | ||
Line 18: | Line 20: | ||
{{Template:Training|links=<br />[http://www.sheetmetalguy.com/bend-allowance.htm Bend Allowance]<br />[http://www.brighthub.com/engineering/mechanical/articles/38675.aspx The Art of Sheet Metal Design]}} | {{Template:Training|links=<br />[http://www.sheetmetalguy.com/bend-allowance.htm Bend Allowance]<br />[http://www.brighthub.com/engineering/mechanical/articles/38675.aspx The Art of Sheet Metal Design]}} | ||
+ | ==maintenance== | ||
+ | the mainteance page is [[48in_sheet_metal_brake_maintenance|here]] | ||
[[Category:Shop Equipment]] | [[Category:Shop Equipment]] | ||
[[Category:Fabrication]] | [[Category:Fabrication]] | ||
− | [[Category: | + | [[Category:Cold Metals]] |
− |
Latest revision as of 01:01, 7 July 2017
Use
For straight line bends in sheet metal. Up to 16 gauge?
Note
When moving the teeth, make sure the dogs on the back are vertical. If they are hanging on by a corner they may fall off and get damaged.
This tool may require training to be used correctly.
Training Resources
Links:
Bend Allowance
The Art of Sheet Metal Design
maintenance
the mainteance page is here