Difference between revisions of "AlarmLock PDL3000"
Jump to navigation
Jump to search
m (→Changing the door code: spellcheck) |
m (Robot: Cosmetic changes) |
||
Line 10: | Line 10: | ||
== Getting an Access Code == | == Getting an Access Code == | ||
− | In order to get the access code, you should A: be a paying member in good standing with the organization, and B: have your [[Bylaws#Eligibility | id checked]] by 2 board members. | + | In order to get the access code, you should A: be a paying member in good standing with the organization, and B: have your [[Bylaws#Eligibility|id checked]] by 2 board members. The best time to get your ID checked is at a general meeting which occur every Tuesday at 8:00pm. |
== Reprogramming the Lock == | == Reprogramming the Lock == | ||
Line 18: | Line 18: | ||
== Sharing the door code == | == Sharing the door code == | ||
− | * | + | * Please don't share the door code with non-members |
− | * | + | * If you don't have the ability to verify membership status, please don't give out the door code. |
== Changing the door code == | == Changing the door code == |
Revision as of 14:15, 17 March 2014
Owner/Loaner | PS:One |
---|---|
Serial Number | {{{serial}}} |
Make/Model | PDL3000 |
Arrival Date | {{{arrived}}} |
Usability | yes |
Contact | {{{contact}}} |
Where | Installed on Front Door |
Authorization Needed | yes |
Hackable | yes |
Estimated Value | ~$1000 |
Host Area | {{{hostarea}}} |
Getting an Access Code
In order to get the access code, you should A: be a paying member in good standing with the organization, and B: have your id checked by 2 board members. The best time to get your ID checked is at a general meeting which occur every Tuesday at 8:00pm.
Reprogramming the Lock
The full manual is available at http://www.alarmlock.com/images/pdf/ETPDL_PDL3X00_WI1021C.07_PROG.pdf
Sharing the door code
- Please don't share the door code with non-members
- If you don't have the ability to verify membership status, please don't give out the door code.
Changing the door code
Door code logic: each allowed code is associated with a user id between the numbers 12 and 50, inclusive.
The door codes are documented on a User Code Record Sheet that is stored in the safe.
Programming the door
{MASTER CODE} A
You are now in program mode until you hold a button for 3 seconds.
Adding
A 2 A {User ID} A {CODE} *
Deleting =
A 2 A {USER ID} *
Erasing All Programing
- Remove battery
- Hold down A for 10 seconds (drain the capaciters)
- Reinstall Battery
- withing 5 seconds of hearing 3 beeps, Hold A until it beeps more
- The lock is now reset, the master programming code is now the default.